Fujitsu PRIMERGY TX2550 M5, Upgrade And Maintenance Manual

Page: 345 / 636

9.5.3 Replacing the OCP module
Upgrade and Repair Unit
(URU) Hardware: 10 minutes
Tools: Phillips PH1 / (+) No. 1 screw driver
Four MAC addresses are stored on the system board.
When replacing an OCP module by an OCP module with different
number of ports (e.g. 2-port to 4-port), additional MAC addresses are
available. Inform the customer about these MAC addresses.
MAC addresses will be changed by replacing the system board. Inform
the customer about that before starting the task. After doing the task,
inform the customer about the changed MAC addresses.
Note for OCP module PLAN EP 2x 25G/10G:
Two MAC addresses are stored on this OCP module. When replacing a
PLAN EP 2x 25G/10G OCP module, MAC addresses are changed.
Inform the customer about these new MAC addresses. MAC addresses
will not be changed by replacing the system board.
Preliminary steps
▶
"Shutting down the server" on page 49 .
▶
"Disconnecting the power cord" on page 50 .
▶
"Getting access to the component" on page 51 .
▶
If, applicable, remove the riser module, see "Removing the riser module" on
page 86 .
Removing the defective OCP module
▶
Remove the OCP module, see "Removing the OCP module" on page 343 .
Installing the new OCP module
▶
Install the OCP module, see "Installing the OCP module" on page 340 .
Expansion cards and backup units
TX2550 M5 Upgrade and Maintenance Manual 345