Fuji Xerox DocuPrint CP215 Series, User Manual

Page: 56 / 246

56 Printer Connection and Software Installation
Wireless Connection (DocuPrint CP215 w Only)
This section describes how to connect the printer to a computer via wireless network.
Confirm that the Ethernet cable has been disconnected from the printer and the
( Wi-Fi ) LED is
blinking before configuring the wireless connection.
IMPORTANT:
• The Wireless LAN feature is not available in all locations. Please check with your local Fuji Xerox
representative for availability of wireless in your location.
• If you are using a method other than WPS to configure your wireless network settings, be sure to get the SSID
and security information from a system administrator before starting the setup procedure.
• Be sure to configure necessary settings on the wireless LAN access point (Registrar) or router before starting
the printer setup. For information on the access point or router settings, refer to the manual supplied with the
product.
The specifications of wireless setting function are described below:
Item Specification
Connectivity Wireless
Connectivity Standard IEEE 802.11b/802.11g/802.11n compliant
Bandwidth 2.4 GHz
Data Transfer Rate IEEE 802.11b mode: 11, 5.5, 2, 1 Mbps
IEEE 802.11g mode: 54, 48, 36, 24, 18, 12, 9, 6 Mbps
IEEE 802.11n mode: 65 Mbps
Security 64 (40-bit key)/128 (104-bit key) WEP, WPA-PSK (TKIP, AES), WPA2-PSK
(AES) (IEEE 802.1x attestation function of WPA 1x non-corresponds),
Mixed Mode PSK
Certifications Wi-Fi, WPA2.0 (Personal)
Wi-Fi Protected Setup
®
(WPS)
*
Push Button Configuration (PBC), Personal Identification Number
(PIN)
*
: WPS 2.0 compliant. WPS 2.0 works on access points with the following encryption types: Mixed Mode
PSK, WPA-PSK-AES, WPA2-PSK-AES, WPA-PSK-TKIP, Open (No Security)