6.5 Checking Printer Status via E-mail
77
Rules for Using Commands
Use each command according to the following rules.
• Prefix all commands with “#”, and specify the #Password command at the top of the
e-mail.
• Command lines without “#” are ignored.
• Write one command on each line and separate each command and parameter with a
space or a tab.
• When the same command is written two or more times in one e-mail, the second and
subsequent commands are ignored.
Example of Commands
1.
When the read only password is “ronly”, and to check the printer status.
2.
When the full access password is “admin”, and to set the recipient e-mail address to
“[email protected]”.
3.
When the full access password is “admin”, and to set the recipient e-mail address to
“[email protected]”, then confirm the setting result on the network settings list.
Note
• Describe the “#SetMsgAddr” command before the “#NetworkInfo” command. If they are written in
reverse, the information retrieved by the “#NetworkInfo” command and the result of executing the
“#SetMsgAddr” command may differ.
#Password
ronly
#Password
admin
#SetMegAddr
#Password
admin
#SetMegAddr
#NetworkInfo
