Fuji Xerox DocuCentre 1055, User Manual

Page: 127 / 245

Storing and Handling Paper
127
• When paper feeding starts and the selected tray malfunctions.
When [Paper Supply] is not set to [Auto] or no other target tray contains paper the same
size, type and orientation, the machine stops printing and message “Tray X is out of
paper” displays.
NOTE: Tray 5 (bypass tray) cannot be used with Auto Tray.
NOTE: System Administrator access must be set to [On] for [Auto Tray], and target
trays and priorities must be specified. For more information, refer to Auto Tray Switch
in the Setups chapter on page 141 and Tray Priority in the Setups chapter on
page 141.
When not in use, the paper trays can be opened and paper can be loaded while the
machine is running. However, do not open the active tray. This will cause the machine
to stop.
Storing and Handling Paper
Always use high-quality, xerographic-grade paper in the machine. Damaged, curled, or
damp paper can cause jams and image quality problems. Follow these simple rules to
store paper:
• Store paper in dry conditions, away from extreme heat or cold, such as radiators or
open windows.
• Store paper flat on a shelf or pallet above floor level.
• Leave the paper wrapped and boxed until ready to be used.
• Re-wrap partly used packages of paper.
NOTE: Paper should not be stored in the paper trays.
Supported Paper Sizes and Types
This section lists the sizes and types of paper that can be used with the machine.
Supported Paper Sizes
The following table lists the paper sizes supported for each paper tray and duplex kit.
NOTE: For the capacity of each tray, refer to Specifications in the Appendix chapter
on page 209.