IP PBXs USER MANUAL
www.fs.com
56
Denoise RX/TX
: The denoise parameter will help on noise reduction of the noisy analog lines, especially when gains have been
increased on the lines.
Echo Cancel When Bridged
: It allows echo cancellation to be enabled or disabled for calls that are bridged between two TDM
devices. As most of the time, the calls between two TDM endpoints will not have any echo, so this option is not required.
Echo Training
: The time length setting of echo training.
9.4
Voicemail Settings
Voicemail settings can be used to configure global voicemail options for all extension users.
Max Greeting Time
sets the max greeting message duration the extension users can record in their mailbox to greet the callers
when they entering voicemail.
Dial ‘0’ for Operator option if enabled, the callers can press 0 to call the operator extension.
Message Format sets the voicemail audio file format to be saved in the IP PBX system.
Maximum Messages
sets the maximum number of messages can be saved in the system for each extension user.
Max Message Time
sets the maximum duration of a single voice message can be accepted by IP PBX system.
Min Message Time
sets the minimum duration of a single voice message can be accepted by the IP PBX system, message duration
less than the Min Message Time will be discarded by IP PBX system.
Say Message Caller ID
: Announce caller ID when listening to the message on user extension.
Say Message Duration
: Announce message duration when listening to the message on user extension.
Play Envelope
: Announce date time and caller ID when listening to the message on user extension.
Allow Users to Review
: Allow callers to review their message before saving.
9.5
Module Settings
Notice
Module Settings are only for configuring digital module cards (El/T1, BRI) on PBX-C302 and PBX-C503 IPPBX systems. Ignore this part if
you are using FXS/FXO/GSM modules.
Path:
Telephony -> Preferences -> Module Settings
PBX-C302 and PBX-C503 IPPBX systems need proper module settings to load correct drivers and configure files to drive the E1 and BRI
telephony modules.
Default module settings are with module types FXS/FXO/GSM on both telephony module slots. So if you don’t have E1 and BRI modules