IP PBXs USER MANUAL
www.fs.com
33
Input Volume
: Sets the volume of the incoming calls from the FXO channels.
Answer Polarity Detection
: When enabled, FXO (FXS signaled) ports watch for a polarity reversal to mark when an outgoing call is
answered by the remote party.
Hangup Polarity Detection
: In certain countries, a polarity reversal is used to signal the disconnection of a phone line. If enabled,
the calls will be considered “hang up” on a polarity reversal.
Fax Detect
: Enable or disable fax auto detection on this trunk.
Caller ID Signaling
: Setup caller ID signaling for this trunk line instead of using global caller ID signaling.
Prompts Language
: You can choose a desired language of the system voice prompts to play to the incoming calls from this trunk.
For example, if the call is not answered or the user is busy, the IPPBX system will notify the caller to leave a voice message in the
language you set.
Busy Count
: Specify how many busy tones to wait for before hanging up, and it’s configurable only if Busy Detection is enabled.
Busy Pattern
: If busy detection is enabled, it is also possible to specify the cadence of your busy signal.
Busy Detection
: Enable busy tone detection, it is also possible to specify how many busy tones to wait for before hanging up.
Quick Send Number
: When enabled, your calls will get through faster, as all numbers sent through this trunk will always be added
with“#” at the end, it will cause the carrier to switch the calls immediately instead of waiting till digits timeout.
Caller ID Start
: Caller ID detection option for this trunk instead of using global settings. For more information please refer to
Analog Settings
.
6.1.2
E1 Trunks
Path:
Telephony -> Outbound Control -> Trunks
If your PBX-C302 or PBX-C503 IPPBX system has E1 module installed, you’ll have an E1 trunk available for inbound and outbound phone
calls.
Click on the
button to configure the E1 (PRI) trunk when needed.