Friendly Robotics robomower RL1000, Service Manual

Page: 71 / 213

3
16
3.2.3 Mowing Problems
Important Safety Information!!!
PRIOR TO ANY OF THE ACTIONS SUGGESTED BELOW
REMOVE THE POWER PACK.
Always wear thick protective gloves when handling or cleaning around the blades
3.2.3.3
‘Check mow
height’ message
Confirm ‘Mowing’ is set to
‘on’ (under ‘User
Preferences’ menu)
YES
Is the mowing
deck blocked
with grass
clippings and
debris?
NO
Does the
message
problem appear
again?
Robomow OK
Uncut lane left
behind the
Robomower
Mowing motors do
not start but the
Robomower
moves on the lawn
Lift the Robomow by the front
handle and confirm nothing is
blocking the blades
Robomow should be left to cool
off till the ‘Cooling, wait…’
message is changing to ‘Press GO’
– then press the ‘GO’ button to
continue the operation
3.2.3.4
‘Mow overload –
Cooling, wait…’
message
NO
YES
Carefully remove the grass
clippings and allow the lawn dry
before commencing mowing
Clippings and debris in mowing deck
Perform ‘Thermistors test’ under ‘Service’ menu (See section 5.3.9)
Perform ‘Mowing motors test’ and refer to fault number.
Try to rotate each blade (carefully, wearing a glove) and make sure
all blades rotate easily and freely (Dull blades should be replaced –
High cut blades – MRK0002A / Low cut blades – MRK0003A)
Remove Top Cover and check tab connections on motors and on
the Main Board
Confirms the cables are not damaged
Replace the Mowing Assembly (MSB0065B)
Replace the Main Board (SPP0019B)
Loose branches, fruits, rope
etc. on the lawn can block the
blades operation
Adjust the ground clearance
and cutting height to the
highest position and retry
3.2.3.2
3.2.3.1