6
21
1. Make sure the charger is plugged into a standard 110V or 220V household outlet.
2. Connect the charging plug to the Robomower at the manual controller base.
3. Pivot it up on its hinges, connect the charger plug and pivot it back to lie flush with the
surface.
4. The display will read “Charging…”. The display will read “Fully Charged” or “Ready,
keep charging” when ready for operation.
5. The charger is for indoor use only, on dry surface. Never charge in areas where water
is a potential hazard.
6. The Robomower should be charging at all times when not in use. Continuous charging
does not harm the batteries.
Note:
The mower will alert when battery voltage is low (below the voltage level, which the
‘Recharge battery’ message had been displayed). In such a case an immediate charging is
required.
Cautions:
(1)
Operating the Robomower prior to having a ‘Fully charged’ or ‘Ready, keep charging’
message will reduce the battery life.
(2)
Leaving the Robomower without charging after the ‘Recharge battery’ message is received
will cause a deep discharge, which will reduce the battery life and capacity. In such a case the
battery will dry in several days.
(3)
Leaving the Robomower without charging after the ‘Fully charged’ or ‘Ready, keep
charging’ message is received will cause the battery to dry in 6-10 weeks.
Winterizing charging procedure
The following procedure is recommended for extended storage periods, during the winter and
for those households where the Robomower is stored in a geographic location where regular
winter temperatures often drop below freezing:
1. Charge the battery until a ‘Fully Charged’ or ‘Ready, keep charging’ message is
displayed.
2. Remove the battery and store outside the mower in a cool dry environment.
3. Repeat this process every 3 months.
4. If temperatures should drop below -20ºC (-4ºF), follows steps 1 through 3, and store the
battery in a warmer place.
5. The Robomower should be charged at temperatures lower than 60ºC (140ºF) and higher
than 0ºC (32ºF). Exceeding these conditions will cause a ‘High/Low temp – disconnect
charger’ message to be displayed, until the temperatures return to the safe charging range.
6. Do not store or charge the Robomow with items pressing against the bumpers. Do not
store or charge the Robomower if it is positioned on its bumpers.
Summary of Contents for robomower RL1000
