Stop
cause #
Message
Description
128
Max dist reached
Robomow has reached the maximal Edge distance during the
“Wire position test"
129
Test result: ‘result’
Termination of the Edge termination test
130
Test result: ‘result’
Termination of the docking station entry test
131
Docking
problem
Robomow has slid off the docking station more than 5 times
during the current charging process
132
Docking
problem
Robomow has slid off the docking station more than 5 times
during the current charging process
134
Low
temperature
Ambient temperature is too low for more than 12 hours during the
charging process
135
High
temperature
Ambient temperature is too high for more than 12 hours during the
charging process
136
Charging
failure
Charging
problem
137
Charging
failure
Charging FET temperature is too high for more than 3 hours
during the charging process
138
Check P. switch
Perimeter switch problem
139
Check
Power
No wire or charger voltage are detected in the docking station for
more than 1 minute
140
Check
Power
Charging
problem
141
STOP button was pressed during automatic operation
142
Remote was taken out during automatic operation
143
Left/Mid/Right mow
problem
Disconnected or burnt Left Right or Middle mowing motor
144
Start
elsewhere
Robot stuck monitor detection.
Robot is stuck in place for too long.
145
One of the
following:
No wire signal
Mowing overload
Drive overload
Auto restart mechanism stop.
5
32
Summary of Contents for robomower RL1000
