3
3.2.2 Power & Charging Problems (con.)
12
3.2.2.2
‘Charging
Failure’
message
Refer to Service
Bulletin
#RL0305-07
(Section 7)
Mower
is ok
Ambiance
temperature during
charging is > 160ºF
(70 ºC) or < 32ºF
(0 ºC) for more
than 12 hours
?
NO
YES
Make sure the
mower is charged in
the suitable
temperatures range
YES
Does the Main
Board P/N is
ESBC045B?
NO
Is the
message still
displayed?
After many
hours
Immediately
Is the message
displayed
immediately as the
mower is connected
to the charger or
after a few hours of
charging?
NO
Is the
message still
displayed?
YES
NO
Mower
is ok
Replace Main Board (SPP0019B)
and follow the instructions
attached to the spare part board
(Service Bulletin) – use the most
updated S/W version flash and
complete the following settings
(under the ‘Service’ menu):
o
‘Learn wire sensors’ (Refer to
chapter 5.3.3)
o
‘Edge Calibration (Refer to
chapter 5.3.2)
o
‘Set country’
o
‘DK Calibration’ (Refer to chapter
5.3.1)
Disconnect the Power
Supply, perform reset by
lifting the Power Pack from
mower and re-insert it after
10 seconds and reconnect
the Power Supply
In any case of charging
problem or failure, it is
recommended first to
perform the charging
test as explained in
section 5.4.9 (page
5.13).
YES
Summary of Contents for robomower RL1000
