4.2.12 Front wheel spring/locker replacement
Required tools: Wide flat screwdriver
Procedure duration: 10 minutes
NOTE:
Read
Service Bulletin #RL0536-05
- Front Wheel Detent Change (
Section 7.1
) before
starting this procedure.
A. Remove the Power Pack from the Robomow.
B. Remove the cover, as outlined in
section 4.2.1
.
C. Locate the broken spring clip / stopper and remove it from its place.
D. Insert the new part, as illustrated in the Figures below:
Figure 4.2.12.1
Insertion of the first
side of a spring clip
Figure 4.2.12.2
Insertion of the front
wheel stopper to it place
E. Squeeze the old configuration spring clips as illustrated in Figure 4.2.12.3 below.
F. Add the two springs (in the new configuration) the secure the stopper in its place, as illustrated
in Figure 4.2.12.4.
Figure 4.2.12.3
Proper attachment of the Thermistor
to the Drive motor shading
Figure 4.2.12.4
Proper position of the front
wheel stopper with the springs
G. Rotate the front wheel height adjustment and verify it “clicks” into place every turn.
H. Return the cover as outlined in
section 4.2.2.
I. Complete the
General Test
as outlined in
section 5.1
.
4
46
Summary of Contents for robomower RL1000
