Fri-Jado MCC 120, Service Manual

Page: 76 / 105

Page 76 Service Manual MCC Cold US 20220700
10.8 Led light Replacement
All LED Lights are mounted in the same way.
1. Remove side glass panes. ( Refer 7.2)
2. Remove column cover.
(two screws, one on top backside and
one at the bottom back side)
3. Pull off column cover.
4. Remove screw holding the LED housing . Column screw (top)
5. Disconnect connector in Column, before you do so,
make a note of the placing of the red and black cable in the connector.
6. Take LED light out of LED light holder, and place new LED.
7. Connect the wires from the new LED in the column, taking care of the notes you
made regarding the red and black cable.
10.9 Controller Replacement
1. Open Electric box ( refer 11.11)
2. Unscrew the brown and Blue wire
(Make note of connection points)
3. Unscrew the four black wires.
(Make note of number and connection position)
4. Using a flat screwdriver push out
the controller to the front of the box
5. Place new controller, by pushing it in.
6. Connect wires again, to the marked positions (point 2 and 3)
7. Check all parameter settings according the parameter list.(Chapter 9)