Fri-Jado MCC 120, Service Manual, Page: 56 / 105

Page 56 Service Manual MCC Cold US 20220700
8.1
Parameter MCC Cold Settings (Self Serve)
MCC Cold SS Eliwell EWPlus 974 EO
Table of "user" menu paramters
Parameter
Description Value Unit
SEt Temperature Setpoint
1
°C
diF Compressor relay activation differential 1 °C
HSE Maximum value that can be assigned to the Setpoint 5 °C
LSE Minimum value that can be assigned to the Setpoint -1 °C
dty Type of defrost (0 = electrical, 1 = reverse cycle, 2 = "Free") 0 num
dit Interval between the start of two consecutive defrost cycles 3 hours
dEt Defrost timeout; determines the maximum defrost duration 30 min
dSt Defrost end temperature (determiend by evaporator probe) 4 °C
FSt Fan stop temperature 50 °C
Fdt Fan activation delay after a defrost cycle 0 min
dt Coil drainage time 0 min
dFd Allows to select the evaporator probes exclusion during defrost n flag
HAL Maximum temperature alarm 10 °C
LAL Minimum temperatre alarm -30 °C
tAO Temperature alarm signal delay time 30 min
dCS Deep cooling cycle setpoint -1 °C
tdC Deep cooling cycle duration 0 min
OSP Offset on setpoint 0,5 °C
OdF Intervention differential correction 4 °C
dnt Duration of night mode 10 hours
DFt Duration of fast cooling mode 1 hours
SPn Night mode setpoint 1 °C
dFn Night mode offset 2 °C
SPF Fast cooling setpoint -1 °C
dFF Fast cooling offset 0,1 °C
LOC LOCk Setpoint change shutdown n flag
PS1 Password 1 0 num
CA1 Calibration 1 (Pb1) 5 °C
CA2 Calibration 2 (Pb2) 0 °C
CA3 Calibration 3 (Pb3) 0 °C
ddt Display mode during defrost 2 num
Ldd Timeout value for display unlick 30 min
H42 Evaporator probe present y flag
rEL firwarme rELease
tAb tAble of parameters
Table of "installer" menu parameters