Freescale Semiconductor Microcontrollers, Manual, Page: 740 / 892

Debugger Engine Commands
Commands Overview
740 Microcontrollers Debugger Manual
Command Syntax Terms
address
A number matching a memory address. This number must be in the ANSI format (i.e. $ or
0x for hexadecimal value, 0 for octal, etc.).
Example: 255, 0377, 0xFF, $FF
NOTE
address
can also be an expression if constant address is not specifically
mentioned in the command description. An expression can be: Global variables
of application, I/O registers defined in
DEFAULT.REG
, definitions in the
command line, or numerical constants.
Example : DEFINE IO_PORT = 0x210
WB IO_PORT 0xFF
range
A composition of two addresses to define a range of memory addresses. Syntax is shown
below:
address...address
or
address , size
where size is an ANSI format numerical constant.
Example:
0x2F00...0x2FFF
Refers to the memory range starting at 0x2F00 and ending at 0x2FFF (256 bytes).
Example:
0x2F00,256
Refers to the memory range starting at 0x2F00 , which is 256 bytes wide. Both previous
examples are equivalent.
fileName
A DOS file name and path that identifies a file and its location. The command interpreter
does not assume any file name extension. Use backslash (\) or slash (/) as a directory
delimiter.
The parser is case insensitive. If no path is specified, it looks for (or edits) the file in the
current project directory. When no path is specified, the default directory is the project
directory.