Freescale Semiconductor Microcontrollers, Manual

Page: 381 / 892

381 Microcontrollers Debugger Manual
15
HC08 ICS P&E Multilink/
Cyclone Pro Connections
In-Circuit Simulation (ICS) Mode is a P&E Microcomputer Systems mode of operation
that is a hybrid between In-Circuit Debugging and Full Chip simulation. P&E has
combined the benefits of each of these modes, while minimizing their respective
deficiencies.
ICS mode simulates the CPU core instructions on the user's PC. However, Inputs/Outputs
are read directly from the user's development device, and certain modules are run on the
actual device. Any instructions that affect an I/O location, for example,
lda PORTA
or
sta PORTA
, also use data from the real device. This allows for all the benefits of full
chip simulation (Cycle by Cycle accuracy, unlimited breakpoints, and speed, to name just
a few), while allowing the obvious benefit of garnering relevant signals from actual
hardware.
In-Circuit simulation requires a user to have a connected MCU Device, be it a
development board, prototype hardware, or simply a device placed in a simple circuit on a
breadboard. Once connection is established, the P&E Interface loads a
.MON
file to the
microcontroller itself. This
.MON
file is the ICS-Kernel; it constantly runs on the device,
and interacts with the P&E software to provide information about changing I/O and any
peripherals that are running on the device itself.
The following modules are run on the actual device when in ICS mode, and as such their
Simulation commands become unnecessary, and therefore do not function:
I/O ports, SCI, SPI, IRQ, ADC, LCD, KBI.
All other modules function as fully simulated modules. For information about relevant
simulation commands, see the
HC08 Full Chip Simulation section.