Freescale Semiconductor Microcontrollers, Manual

Page: 633 / 892

ColdFire V1 Full Chip Simulation Connection
FCS Visualization Utilities
633 Microcontrollers Debugger Manual
If you have chosen a connection from or to the virtual SCI port, you can also specify, in
the
Virtual SCI section, which ports to use as virtual SCI ports. This enables you to make
a connection to any port in the FCS framework.
Input and Output File
You can use a file as an input stream for the terminal component or redirect the output to a
file.
To use a file as an input stream, make sure that at least one connection exists from the
input file to any output device. Then you can open an input file by choosing
Input File
from the context menu. As soon as you press the OK button in the File Open dialog, input
from the file starts. The file closes as soon as the end of file is reached or when you choose
Close Input File from the context menu.
When the input file reaches its end a CTRL-Z character (ASCII code 26 decimal) is sent to
all output devices receiving characters from the input file to notify them that the file
transfer is complete.
Redirecting input devices to an output file is a similar process. Choose your connections
from input devices to the output file. Then open or create your output file by choosing
Output File from the context menu. If the file does not exist the debugger creates it.
Otherwise you can choose to overwrite or append the existing file. To stop writing to the
output file choose
Close Output File from the context menu.
File Control Commands
You can open and close input and output files through special Escape sequences in the
data stream from the serial port or virtual SCI.
Table 28.15 illustrates the different possible
commands and associated Escape sequences where
filename
is a sequence of
characters terminated by a control character (e.g. CR) and is a valid filename.
Table 28.15 Terminal File Control Commands
Escape Sequence Function
ESC “h” “1” Close output file.
ESC “h” “2” filename Open output file.
ESC “h” “3” filename Open output file and suppress output to terminal display.
ESC “h” “4” Close input file
ESC “h” “5” filename Open input file.