79
Good transmission level: LED blinks at a medium
frequency meaning 50% - 69% transmission level.
Low transmission level: LED blinks at a slow
frequency meaning 25% - 49% transmission level.
If in current location there is no connection to the
nearest Repeater or Receiver the LED will
continuously blink red.
4. At the start of the signal test the Logger icon on the Map
View blinks.
5. To stop the signal test, give the logger button a short
press. After one minute the test will cease in any case.
When the test ends, the LED emits a few short red blinks
quickly followed by several green blinks.
Running Signal Test from DataNet Software
Right-click the logger icon on the Map View and select the
Signal Test
option. The signal test will proceed on the logger
as described in Step 3 above.
Note
: Performing transmission level test consumes a lot of
battery power; do not repeat this test too many times.
3.13.4.
Call Unit from Software
To locate the logger via the software, right-click the logger
icon on the Map View and select the
Call Device (LED)
option. The logger LED will alternate between slow green and
red blinks and after several blinks it will stop.
