73
•
Logger – SR RPTR
Device is operating as a Short Range Repeater. Refer to
section
2.8.5 for more details.
Leave Network
If this option is selected, the unit will first leave the network
and then reset itself. The scan network procedure described
in section
3.12.3 will begin. The only exception to this
procedure is that even if the last connected network is found
during the scan, the unit will not automatically connect to it.
Note:
If the logger was in Run mode prior to sending the
Leave Network command the software will download all data
from the unit first and then force it to leave the network.
Reset Unit
When the unit is reset, upon start up it will automatically scan
for networks. The unit will automatically connect to the
previously connected network assuming it was found in the
network scan.
Following reset the unit will continue to operate according to
its last set up instruction. For example, if the logger was in
Run mode, then after reset it will continue to run and record
data.
Turn Off Unit
Selecting this option will shut the unit down. You can turn the
unit on again by pressing the
Scroll
button.
It is recommended to turn off the unit when it is not in use.
Leave network
