![background image](http://html1.mh-extra.com/html/formax/cut-true-29h/cut-true-29h_operators-manual_2320002044.webp)
Page
44
/
62
8.1.2.12.Remove (loosen) the fixing screws 4 (fig.33) so that the knife falls under its own weight
on the cutting bar with its entire length.
8.1.2.13. Tighten the adjustment screws 5 (fig. 33) as far as they will go, so that the blade of
the knife is cut into the cutting bar, approx. 0.3 mm.
WARNING
Performing too-deep cuts may result in shortened blade life!
8.1.2.14. Tighten the fixing screws 4 (figure 33)
8.1.2.15. Switch on the power supply of the electrical system by turning the main switch knob 3
(fig. 33) to position "I".
8.1.2.16. Turn off the "knife change" function on the programmer 1 (fig.33)
8.1.2.17. Press simultaneously the push buttons 2. The knife will return to its upper position.
8.1.2.18. Turn off the power supply of the electrical system by turning the main switch knob 3
(fig. 33) to the "0" position
8.1.2.19. Firmly tighten the first screw on the left side of the knife. 2 (Fig. 31).
8.1.2.20. Turn on the power supply of the electrical system by turning the knob of the main
switch 3 (fig.33) to position "I"
8.1.2.21 Switch on the power supply to the control system by pressing the green push button 3
(fig.22).
8.1.2.22 Carry out a cutting test. If the knife does not cut the pile to the last sheet, repeat steps
8.1.2.7.
8.1.2.23 Attach cover 2 with the screws 1 (fig.34)
1
2
1
1
Figure 34.