Page
43
/
62
8.1.2.7 Slightly unscrew the first screw on the left side of the clamping screw 2 (Fig. 31), taking
care that the screw head does not protrude above the knife beam sliding plane.
8.1.2.8 Press the "Change knife" function on the touchscreen 3 (Fig.22)
8.1.2.9 Pressing the push buttons, 2
(Fig. 33) at the same time, start the cutting cycle. The
knife will stop in the lower position.
8.1.2.10. Switch off the power supply of the electrical system by turning the main switch knob,
3 (fig. 33) to the "0" position
Figure 32a.
8.1.2.11. Screw in the bolt 2 lightly (fig.32a)
Figure 33.
