Gas Flow Analyzer
6
6-11
The
PEAK
soft key toggles the RT200 peak-detect mode on and off, for flow and
pressure signals. When in peak-detect mode, the peak of the current signal (flow or
pressure) is shown for each breath.
The
RESET
soft key resets the RT200 mode, turning off any active functions, and
resetting the special functions.
The
FCTN
soft key brings up a menu that allows the user to start a RT200 function and
enter the special function values associated with that RT200 function. The menu is
function sensitive, and the options in the menu correlate to the RT200’s special functions
00, 01, F1, and F2. The values you may set in this menu include: Oxygen Concentration,
Accumulated Tidal Volumes, Correction Mode, Hold Times, Ambient Temperature,
Barometric Pressure, Rise Delay Time, Fall Delay Time, and Trigger Level.
The
SETUP RS232
soft key brings up a screen for setting the baud rate, number of data
bits, and the terminator character. These settings only affect the RT200 emulation mode
and not the other serial communication modes. The default settings are 9600 baud, 7 bits,
and a termination character of carriage return only.
Summary of Contents for VT Plus HF
