Fluke Versiv, User Manual

Page: 58 / 260

Versiv Cabling Certification Product Family
Users Manual
44
To do an Autotest on twisted pair cable
1
Attach permanent link or channel adapters to the main and
remote testers.
2
Make sure that the home screen shows the correct settings for
the job.
To make sure that other settings are correct, tap the test setup
panel, make sure the correct test is selected on the
CHANGE
TEST SCREEN
, then tap
EDIT
to see more settings. Table 2 on
page 39 describes the settings.
3
Connect the testers to the link as shown in Figure 16 or 17.
4
Tap
TEST
on the main tester or press

on the main or
remote tester.
If the tester at the other end of the cable is in sleep mode or is
off, your tester’s tone generator turns on the other tester.
If the two testers are not connected:

Your tester’s tone generator stays on. Then, you can use a
tone probe if necessary to find the cable to connect to the
other tester.
 Or, tap
MEASURE
to do the tests that do not require a
remote tester. Because the tester cannot complete all tests
and some tests always fail with no remote connected, the
result for an Autotest without a remote is always
FAIL
.