Fluke Versiv, User Manual

Page: 229 / 260

Chapter 11: Use Projects
The CABLE ID SETUP Screen
215
The CABLE ID SETUP Screen
To see the
CABLE ID SETUP
screen, tap the
PROJECT
panel on the
home screen, then tap
NEW ID SET
on the
PROJECT
screen. See
Figure 86 on page 216.
Each project can have up to 5000 IDs. If an ID set does not have a
Last ID
, the tester counts the set as one ID. An ID can have a
maximum of 60 characters. Symbols, such as the asterisk, and
accented characters do not increment.
About Next ID Sets
If you do not enter a
Last ID
when you make an ID set, the tester
uses the
First ID
as the
Next ID
. The tester increments the Next ID
each time you save a result.

Numbers increment sequentially:
1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, ... 99, 100, 101...
 Letters increment through the English alphabet:
A, B, C, D, ... Z, AA, AB, AC, AD, ... AZ, BA, BB, BC...
 Numbers and letters do not cause each other to increment:
1Y, 1Z, 1AA, 1AB, ... 1ZZ, 1AAA, 1AAB...
 The tester does not increment symbols or accented characters.
When you use a
Next ID
set, the set under
IDs Untested
on the
CHANGE ID
screen shows only the next ID. To save the next test
with a different ID, tap the
Next ID:
panel, then enter a different
ID.
Each project can have one
Next ID
set. You can use the
Next ID
set
for copper or fiber results.
If your project has only a
Next ID
set, the tester cannot calculate
the percentage of the project that is completed, so the
% Tested
value does not show on the home screen.