Fluke Versiv, User Manual

Page: 100 / 260

Versiv Cabling Certification Product Family
Users Manual
86
To do the FiberInspector test
Refer to Figures 34 and 35.
1
Connect the FI-1000 probe to the type A USB port on the side
of the tester.
2
Install the correct tip on the probe.
3
Clean the connector that you will inspect.
4
Do the FiberInspector test:
To do the FiberInspector test when it is in the project
If the FiberInspector test does not already show on the home
screen:
a. On the home screen, tap the test setup panel.
b. On the
CHANGE TEST
screen, tap the
FiberInspector
test,
then tap
USE SELECTED
.
c. Tap
Test
or press

.
To do the FiberInspector test when it is not in a project
On the home screen, tap the
TOOLS
icon, then tap
FiberInspector
.
5
Insert the probe into the connector.
6
To adjust the focus, turn the dial on the probe clockwise or
counterclockwise.
Figure 36 shows an example of a FiberInspector image.
7
To save the image, tap
SAVE
.
8
On the
SAVE RESULT
screen, select
End 1
or
End 2
, make sure
the
Cable ID
and
End
name are correct, then tap
SAVE
.
Saved FiberInspector results show these icons for
End 1
and
End
2
: