FW-D030-P-MAN-EN-V0102_02
27
5
CHAPTER
Operating the D030-P
The D030-P default mode of operation is the Operator mode.
In Operator mode field information is processed and displayed. What information is displayed
how depends on the configuration settings, as described in "Configuring the D030-P" on page 18
Signals, generated by the flowmeter in the field, are processed real time in the background,
independent from the configured display update speed.
When you press a button, the display will update real time during 30 seconds, after which it will
return to the configured update speed (the lower the configured update speed, the longer the
onboard batteries last).
If the display appears “off”, press a button to see if it activates.
The D030-P button and display functions
The D030-P has three buttons and several operation modes.
The function of each key depends on the active operation mode
in the D030-P. The active
operation mode is visualized by the display.
The default Operator mode is indicated by the status indicators
,
or
.
The D030-P Display Functions
The D030-P has a large transflective LCD with a number of symbols and digits to display
measuring units, status information, trend indication and keyword messages.
The D030-P Key Functions
The following keys are available:
Caution:
• If
is lit, refer to See “Troubleshooting the D030-P” on page 35.
• If the display is blank,
or
are lit, contact maintenance.
RUN
READY
PAUSE
ALARM
PROGRAM
SETUP
Figure 23:
The display functions of the D030-P
Indication of large
display readout
Measuring units large display
readout
Large display trending
(increase or decrease)
Numerical 17mm large display
readout
low battery indicator (replace
when steady)
D030-P status indicators
indication of small
display readout
Alphanumerical small display
readout
RUN
LOW BATTERY
SET-UP
PAUSE
ALARM
PROGRAM
READY
This key is used to access various configuration modes, program items and enter values.
Use this key when you see
PROG
or
ENTER
in the text.
This key is used to START the batch process and to change blinking values and states or to configure the
unit.
Use this key when you see
START
or in the text.
