User manual D030-P Batch Controller
C
ONFIGURING
THE
D030-P – 4
FW-D030-P-MAN-EN-V0102_02
19
Quick Reference Menu
Password Protection
If Setup mode is password protected you get below screen when trying to access:
Password
and
0000
are displayed, the left digit is blinking.
1 Press repeatitly until the correct number in the blinking digit is displayed.
2 Press to move to the next digit and repeat above step for all four digits.
3 When done with all four digits press
ENTER
to confirm:
- When correct, you enter Setup mode and the
indicator lights up.
- When incorrect, you return to Operator mode: Try again.
See "No access (unknown password)" on page 35 for troubleshooting information.
Shelf mode
Mode to deactivate the unit for storage. The unit is switched off. Press
START
twice to switch the unit on and perform a self test.
Operator mode
Setup mode
Program mode
Default operation mode of the unit.
Display indicators:
or
(optional).
Mode to select setup items and see
their settings. Display indicator:
.
Mode to change settings. Display
indicators:
and (blinking)
.
• Unit always returns to
this menu when not oper-
ated for 20 seconds.
• Operator functions and
rights depend on settings
and available options of
your unit.
• To access press and hold
PROG
7 seconds. While
waiting the display shows
.
• You may have to use
and to enter a 4-digit
password. Confirm with-
PROG
.
• To select an item use
buttons
and .
• To exit press and hold
PROG
3 seconds or wait 20
seconds.
• To access the selected
item press
PROG
.
• To change an item use
buttons
and .
• To save changes and exit
press
ENTER
.
• To cancel press and hold
PROG
3 seconds or wait 20
seconds.
Figure 21:
Enter a password to continue
RUN
READY
SETUP
SETUP
PROGRAM
RUN
LOW BATTERY
SET-UP
PAUSE
ALARM
PROGRAM
READY
SETUP
