User manual D030-P Batch Controller
1 –
I
NTRODUCTION
2
FW-D030-P-MAN-EN-V0102_02
The D030-P Display Functions
The D030-P has a large transflective LCD with a number of symbols and digits to display
measuring units, status information, trend indication and keyword messages.
Configuration of the D030-P
"Available D030-P configurations" on page 3 shows that this unit is available in various hardware
configurations to support a wide range of applications. Other models of this type have other
configurations. Contact your reseller for details.
The configuration mode of the D030-P allows you to configure and shape your D030-P towards
your specific requirements. The configuration mode supports all available hardware
configurations of the D030-P and includes several important features such as K-factor,
measurement units, signal settings, etc.
All setting as are stored in EEPROM memory and will not be lost in case of power breakdown or in
the event of an empty battery.
EEPROM Memory
The D030-P contains EEPROM memory that does not loose its data upon power loss.
All configuration settings remain stored in case of a power failure or deactivation of the unit (e.g.
during transport or storage).
Options of the D030-P
The following section describes the configuration options this particular D030-P may have been
equipped with. Other models of this type have other options. Contact your reseller for details.
Figure 2:
The display functions of the D030-P
Indication of large
display readout
Measuring units large display
readout
Large display trending
(increase or decrease)
Numerical 17mm large display
readout
low battery indicator (replace
when steady)
D030-P status indicators
indication of small
display readout
Alphanumerical small display
readout
RUN
LOW BATTERY
SET-UP
PAUSE
ALARM
PROGRAM
READY
Note:
You may optimize battery-life time (type PB only) by optimizing the power-
management functions as described in "Power Management" on page 25.
