Flavor Burst FB 80INT-08, Manual

Page: 58 / 85

57
3. Remove the side support bar from the open
side of the cabinet. (See Figure 151.)
26403
Figure 151
4. Angle the Flavor Burst cabinet inside the
Taylor cabinet, taking care not to pinch or
damage the tubing and pump wires. Center
the internal cabinet from side to side, with
the back end flush to the edge of the back
of the Taylor cabinet. (See Figure 152.)
26404
Figure 152
5. Check all tube and wiring connections and
secure them if they came loose during the
installation. (See Figure 153.)
26405
Figure 153
6. Connect the Drive (Rotor) Motor and
Keypad cables to the electronics board
connections under the bend of the panel.
RECOMMENDED LEFT SIDE
INSTALLATION: Facing the rear of the
cabinet, lead the cables out to the right side
of the electronics panel as shown if the
Injector Assembly is installed on the left side
of the freezer. (See Figure 154.)
26406
Figure 154
ALTERNATE RIGHT SIDE INSTALLATION:
Lead the cables to the left of the panel if the
Injector Assembly is on the right side.
7. Install the electronics panel to the tabs on
the back side of the internal cabinet using
the six thumb screws provided.
RECOMMENDED LEFT SIDE
INSTALLATION: Facing the rear of the
cabinet, pass the 9-Tube Lead through the
right cut-out on the electronics panel and
the pump cables through the left cut-out.
(See Figure 155.)
26407
Figure 155
ALTERNATE RIGHT SIDE INSTALLATION:
Pass the 9-Tube Lead through the left cut-
out on the electronics panel and the pump
cables through the right cut-out.