Flavor Burst FB 80INT-08, Manual

Page: 55 / 85

54
6. Tighten the thumb nut and thumb screw to
secure the Suspension Bracket.
NOTE: THE SUSPENSION BRACKET
SHOULD BE POSITIONED ON THE DRIVE
ASSEMBLY GEAR BOX DURING INITIAL
SET-UP AND DOES NOT NEED TO BE
REMOVED DURING OPENING OR CLOSING
PROCEDURES UNLESS IT REQUIRES A
MORE THOROUGH CLEANING.
7. Fully insert the 9-Tube Assembly into the
Injector Head syrup line opening and rotate
it until motion stops to secure. (See
Figure 138.)
26044
Figure 138
Mounting the 9-Tube Assembly Casing
Mount the 9-Tube Assembly Casing on the side
of the freezer where the 9-Tube Assembly
wraps around. The casing should be mounted
level horizontally and at the same height as the
Injector Assembly so that the syrup lines are
level with the connection at the Injector Head.
The following instructions and illustrations show
a left-side mounting, which is typically the side
with the intake vents. It is recommended to
install the Casing and the 9-Tube Assembly on
the intake vent side to prevent heating of the
tubes and syrup within. In cases where left-
side mounting is not possible, the Injector
Assembly, tubes, and Casing may be installed
on the other side.
1. The Casing Assembly contains very power
magnets to attach to the side of the freezer.
Simply place the assembly in line with the
Injector Assembly with the hinged surface
downward (screws at the top). The curved
ends of the Casing should hang over the
front and back of the freezer and the
assembly should be level horizontally.
(See Figure 139.)
26461
Figure 139
2. Remove the four screws from the top of the
Casing Assembly. (See Figure 140.)
26462
Figure 140