Flavor Burst FB 80INT-08, Manual

Page: 24 / 85

23
6. The following do not need to be sanitized on
a daily basis as part of the daily opening
procedures. However, inspect these areas
and if necessary, clean according to
instructions in the SCHEDULED
MAINTENANCE section: (See Figure 12.)
•
9-Tube Assembly Coupler
•
9-Tube Assembly Tubes
•
Spigot Switch and Bracket
•
Keypad and Keypad Bracket
•
Spout Adapter (clean according
to instructions when freezer
door has been removed)
•
Drive Motor
26011
Figure 12
Assembling the Injector Assembly
The two Injector Head o-rings and the Gear
Cartridge are wear items and will need to be
replaced periodically. Check for wear
occasionally and always keep spares of these
items on hand in the Spare Parts Kit.
1. Place the Gear Cartridge into the Drive
Assembly Gear Box so that the gear teeth
line up with the gear inside the Drive
Assembly Gear Box. (See Figure 13.)
26023
Figure 13
2. Install the Injector Head onto the Drive
Assembly Gear Box and rotate off-center to
secure. (See Figure 14.)
26024
Figure 14
3. Insert the Drive Motor into the Drive
Assembly Gear Box so that all four locking
screws are seated properly and rotate the
motor clockwise to secure. (See Figure 15.)
26025
Figure 15
Installing the Injector System
1. Hang the Suspension Bracket with the
Injector Assembly on one of the lower
freezer door posts. (See Figure 16.)
26040
Figure 16