Flavor Burst FB 80INT-08, Manual

Page: 51 / 85

50
Installing the Keypad and Keypad Mounting
Bracket
The Keypad is the control unit for the Flavor
Burst
®
system. Normal operating functions are
performed using the Keypad and the freezer
draw handle. The Keypad is attached to the
freezer with the Keypad Mounting Bracket.
1. Slide the Keypad onto the main Bracket
plate and assemble the two Bracket parts in
the style that will best suit your freezer and
daily operations. One example is given in
the figure below. (See Figure 119.)
26120
Figure 119
2. Determine the approximate area and side of
the freezer to attach the Bracket that will
best suit your needs. Typically this is the
same side as the 9-Tube Assembly so that
the cable can be contained inside the
9-Tube Assembly Casing.
NOTE: IF YOUR FREEZER HAS AN
INTERNAL SWITCH INSTALLED, MOUNT
THE KEYPAD ON THE SAME SIDE AS THE
SWITCH JACK.
3. Thoroughly clean and dry the face of the
freezer where the Bracket base will be
attached. (See Figure 120.)
Detergent
CLEAN
Water
RINSE
DRY
26121
Figure 120
4. Remove the protective tape from the
adhesive pad. Attach the Keypad bracket
assembly to the desired mounting area.
Ensure there is enough room between the
Keypad assembly and the freezer face to
slide the Keypad off and on the Bracket for
daily cleaning. (See Figure 121.)
26122
Figure 121
5. Fully insert the Keypad stereo plug into the
Spigot Switch jack and ensure that the
connection is fully engaged. (See
Figure 122.)
26123
Figure 122
6. If the freezer has an internal switch, connect
the Keypad stereo plug to the internal
switch jack and ensure the connection is
fully engaged. (See Figure 123.)
26125
Figure 123