Flavor Burst FB 80INT-08, Manual

Page: 53 / 85

52
Assembling the Injector Assembly
1. Place the Gear Cartridge into the Drive
Assembly Gear Box so that the gear teeth
line up with the gear inside the Drive
Assembly Gear Box. (See Figure 129.)
26023
Figure 129
2. Install the Injector Head onto the Drive
Assembly Gear Box and rotate off-center to
secure. (See Figure 130.)
26024
Figure 130
3. Insert the Drive Motor into the Drive
Assembly Gear Box so that all four locking
screws are seated properly and rotate the
motor clockwise to secure. (See
Figure 131.)
26025
Figure 131
Installing the Injector System and
Suspension Bracket
The Suspension Bracket helps stabilize the
Injector Assembly on the freezer. When
properly installed on the freezer, the Bracket
should hold the Injector Assembly level
horizontally, with the Injector Head lined up
directly under the Spout Adapter. The
Suspension Bracket is adjustable to fit many
common freezer models. Additional
Suspension Bracket styles are available for use
with other freezer models. Contact your local
distributor for more information.
The Injector Assembly can be mounted to either
side of the freezer spout. The 9-Tube Assembly
may also come from either side, regardless of
the Injector Assembly’s position. However it is
highly recommended the Injector Assembly is
installed so that the 9-Tube Assembly wraps
around the side of the freezer with the intake
vents (typically on the left side) and not the
outtake vent (typically on the right side). This is
because the outtake vent could warm the syrup
in the tubes and therefore warm the frozen
product as it is served. Installing the tubes on
the side of the intake vents keeps the syrup
cool and the product consistent.
The following instructions and illustrations show
a left-side mounting, which is recommended for
Taylor C707 / C708 freezer. In cases where
left-side mounting is not possible, the Injector
Assembly and tubes may be installed on the
other side.
1. Determine which side of the freezer the
Injector Assembly will be mounted on. The
Suspension Bracket should be installed to
the outside of the Gear Box Assembly.
(See Figure 132.)
26047
Figure 132