Flavor Burst FB 80INT-08, Manual

Page: 46 / 85

45
Keypad Mounting Bracket
Detergent
CLEAN
Water
RINSE
DRY
26141
Figure 105
1. Loosen the Mounting Bracket hand screws
and remove the main plate.
2. Clean both the main plate and the plate
attached to the freezer using a single
service towel moistened with warm
detergent water. Use a brush if necessary.
The hand knobs may also be cleaned
separately.
3. Rinse the Mounting Bracket parts with a
single service towel and clean, warm water
and then wipe dry with a dry single service
towel.
4. Reassemble the Keypad Mounting Bracket
according to instructions.
Injector Assembly Suspension Bracket
Detergent
CLEAN
Water
RINSE
DRY
SANITIZE
26145
Figure 106
1. Remove the Bracket from the Injector
Assembly and disassemble it.
2. Clean the Bracket parts using detergent
water and brush if necessary, then rinse
thoroughly.
3. Place the items in sanitizer solution for at
least 1 minute.
4. Remove parts from the sanitizer solution
and place them on a sanitary tray to dry.
5. Reassemble and reinstall the Suspension
Bracket as directed in EQUIPMENT
SETUP.
Accessory Hanging Bracket and 9-Tube
Assembly Casing
Detergent
CLEAN
Water
RINSE
DRY
26146
Figure 107
1. Using warm detergent water and a single
service towel, clean the Bracket and the
Casing attached to the freezer. If
necessary, the Casing can be removed and
disassembled for a more thorough cleaning.
2. Rinse with a single service towel moistened
with clean water.
3. Dry the Bracket and Casing with a dry
single service towel.