Fischer Panda 10000/9, Manual

Page: 6 / 246

Seite/Page 6 Inhalt/Contens 9.12.14
Inhalt / Contens
8.7 Stopping the generator - see remote control panel data sheet 106
9 Maintenance Instructions107
9.1 Personal requirements 107
9.2 Hazard notes for the maintenance 107
9.3 Environmental protection 109
9.4 Maintenance interval 109
9.5 General maintenance instructions 109
9.5.1
Checks before each start 109
9.5.2 Check of Hoses and rubber parts in the sound insulated capsule 109
9.6 Oil Change Intervals 110
9.7 Checking oil-level 110
9.7.1
Refilling Oil 111
9.7.2 After the oil level check and refilling the oil 111
9.8 Replacement of engine oil and engine oil filter 112
9.8.1
After the oil change 114
9.9 Verifying the starter battery and (if necessary) the battery bank 115
9.9.1
Battery 115
9.9.1.1
Check battery and cable connections 115
9.9.1.2 Check electrolyte level 115
9.9.1.3 Check electrolyte density 116
9.10 Grease lubricated generator backend bearing 116
9.10.1 Exchange of grease lubricated bearing 117
9.10.1.1 Demounting the cooling disc (if existent) 118
9.10.1.2 Demounting the backend bearing 118
9.10.1.3 Installing the new backend bearing 119
9.11 Checking the oil level of the generator end bearing at Fischer Panda generators 122
9.11.1 Oil level check 123
9.11.2 Refilling oil 123
9.11.3 Refiller-Set 124
9.11.4 Screw plug 124
9.12 Replacement of the oil-cooled backend bearing 125
9.12.1 Exchange oil-cooled bearing 125
9.12.2 Demounting the bearing 125
9.13 Ventilating the fuel system 137
9.13.1 Replacement of the fuel filter 138
9.13.1.1 Optional fuel filter with sight glass 139
9.14 Checking the water separator in the fuel supply 140
9.14.1 Replace the air filter mat 140
9.14.2 Alternative replacement of the air filter mat with pull out holder 141
9.14.3 Alternative replacement of the air filter at housing with snap fasteners 143
9.14.4 Ventilation of the coolant circuit / freshwater 144
9.14.5 V-belt replacement for the internal cooling water pump 146
9.15 The raw water circuit 147
9.15.1 Clean raw water filter 147
9.16 Causes with frequent impeller waste 148
9.16.1 Replacement of the impeller 149
9.17 Replacing the Actuator 151