5-6
C
OMMISSIONING
THE
ALINTE
4
PAGE
S
YSTEM
Figure 5.1 Check traverse level
7.
Release the traverse servo-drive by entering:
diagnostics/service/traverse/halt
8.
Align and measure as in steps
3.
and
4.
above.
9.
If the difference between the measurements is greater than
0.5
mm,
then an Engine level adjustment is required:
Adjust the feet to minimise creep and obtain an improved level. A
small adjustment of
1
/
4
to
1
/
2
turn (0.25 to 0.5 mm) on the engine feet
is usually sufficient.
10.
Repeat steps
2
.
to
9
.
until creep is within the specification.
11.
While the carriage moves along the traverse, observe the readhead
LED from the user end and ensure that it remains
green
(and does
not flash) for the
full
traverse. Ignore the
red
limit lights at the service
end.
CARRIAGE
RAIL
BALL CAGE
ALIGN AND
MEASURE
RUN TRAV. TEST
MEASURE AND CORRECT
FOR CAGE CREEP
3
1
2
V-GROOVE
Summary of Contents for alinte4page
