IDENTIFICATION
ID ISC.ANT1710/690 Crystal
Gate Excellence -A/-B
Typical Antenna Configuration
Page 26 of 26
7.3.2 Configuration of a Gate Antenna with Multiplexer
Connect the components as shown in Fig. 13. Almost, all cables should already be installed. Normally the
antenna cables from antenna Type B have to be connected to the multiplexer at OUT3+4 (see also
7.3.3
Setting the Multiplexer
) and the 24V DC power supply at X11 of the terminal board. Also a connection
between X13 GPC-out of the terminal board in Antenna Type A and X13 GPC-out of the terminal board in
Antenna Type B must be installed to supply the LED with power and RS485 bus.
Fig. 14: Connecting the components for a gate consisting of two antennas, reader and multiplexer
LED1
1. Antenna
ID ISC.ANT.GPC
Gate People Counter
Radar Module 1
X6
HF- Antenna
HPDA
135 cm
X1
8,55 m
IN
OUT 3+4
OUT 1+2
LED2
2. Antenna
DC Power
Supply24 V
X3
X2
Multiplexer
ID ISC.ANT.MUXM8
Long Range Reader
ID ISC.LRM2500-B
2. Antenna
ANT1
Lower Loop
Upper Loop
Lower Loop
Upper Loop
