IDENTIFICATION
ID ISC.ANT1710/690 Crystal
Gate Excellence -A/-B
Installation and Wiring
Page 15 of 15
6 Installation and Wiring
Installation and Wiring
NOTE:
•
Before installing the antennas please read 7.1 Project Notes Antenna. The spacing of the
antennas in a gate depends on the antenna configuration.
•
If multiple antennas or gates are connected to different readers, a minimum clearance of 8 m
must be kept between the antennas or gates. For shorter distances (1 m – 8 m) the readers must
be synchronized. The synchronization of the readers (see application note N10311-xe-ID-B.doc) is
only possible in one of the Reader AutomaticModes.
•
At a distance below 1.5 m the antennas must be shielded from each other. Otherwise, the read
range will be significantly reduced.
•
The antennas must have a minimum distance of 20 cm to all larger metal parts! At a distance of
less than 50 cm between the antenna and metal parts the read range will be significantly reduced.
6.1 Mounting Preparation
To mount the antenna, unpack it carefully and open the antenna base. This is done as described in the
following steps:
1. Place the packed antenna on the floor with the top side facing up. Carefully open the box and then
remove the antenna.
Fig. 3: Packed Antenna
2. Afterwards, the antenna must be carefully placed on the floor again. Now the two fastening screws
(hexagon socket AF 2,5) must be removed from the antenna base cover. Carefully remove the cover
from the antenna base by sliding it upwards (Fig. 4).
