Version 6
Operating instructions
CCS Silver
Firmware 2021-01-14
Page:
58
of:
72
FAUDI Aviation GmbH, Scharnhorststraße 7 B, D-35260 Stadtallendorf
Manual_CCS_silver_Eng_
operation_version6.docx
3.2.6.2.2 Reset Alarm using external switch
Alarm could either be reset using an external reset switch.
CCS consists of different digital inputs. Digital input RESET has been setup to reset Alarm or
Warning via external switch, e.g. a key switch. Please refer to CCS installation instructions
for hardware setup.
3.2.6.2.3 Reset Alarm via Modbus
Please refer to Modbus Application note.
3.2.6.3 History
The CCS logs data through every refuelling process You can see the average and maximum
water contamination measured by the AFGUARD® for the Inlet and the Outlet of the filter
(provided the corresponding sensor is installed). The history can be shown on the screen.
The last 50 refuelling processes are stored on the intern memory of the CCS. A USB drive is
not required for showing the last 50 refuelling processes on the screen.
To call the history, click on the History button on the dashboard.
The history page opens. You see a bar chart there, which shows the maximum / average
contamination.
With the buttons below, you can switch the view to Inlet and Outlet and between average and
maximum values. If there is no AFGUARD® installed in Inlet or Outlet, the corresponding
buttons disappear.
The chart begins with a bar on the right side. At the end of a refuelling process, the bar is
shifted one step to the left. If the left edge of the chart is reached, the last data set gets
deleted, so the history diagram acts as a FIFO Memory.
