Version 6
Operating instructions
CCS Silver
Firmware 2021-01-14
Page:
39
of:
72
FAUDI Aviation GmbH, Scharnhorststraße 7 B, D-35260 Stadtallendorf
Manual_CCS_silver_Eng_
operation_version6.docx
If you like to export the configuration as a backup to install it on related CCS Silver systems,
then click Export Config
3.2.4.3.13 Export Config
If you click Export Config, the following screen appears:
Click Store on USB to export the configuration file. You can get the config file by unplugging
the USB drive or easier: by a click on Download. Then you can download the file via your
web browser. Note: The browser must allow pop-ups and support File transfer Protocol.
If you are finished click on the Home Button to get to the dashboard or click 2x << Back to
get to the setup.
3.2.4.3.14 Check for the right settings
If your sensors are connected wrong, then the dashboard may show you some errors. E.g. if
no sensors are connected yet, the screen could look like the following:
Make sure every sensor is connected properly If you don’t connect a sensor which is
expected by the system, you will see Broken Wire Errors on the main screen. In this case,
check the connections first and apply a reset. You can apply a reset by hardware via the
reset input where you can connect a switch or via software by a click on Reset Alarm
If you accidently did not set “
N/A
” for all sensors which are not available to the system you
should launch the installer again.
3.2.5 Setup
At the first launch of the CCS you should use the installer to set up the system. If you want to
change any settings later, you can go to the setup.
