Farmet FALCON 3, Operating Manual

Page: 58 / 99

Manual
FALCON 3 | 4 | 6 | 8
58
│
99
In the case of two metering units (one for odd coulters, one for even coulters), we must enter do the total sowing
rate in the display unit ½ for each metering unit. Example: the required rate is 200 kg / ha - the required rate on
both engine 1 and 2 must be set at 100 kg / ha. In case of sowing two different crops, enter the required sowing
rate for each crop for each metering unit. In case of sowing with only one metering unit, enter the required
sowing rate for one metering unit and enter 0 kg / ha for the other.
Picture 35 – Setting the seed rate for the respective metering unit
-
Third step is the calibration step:
Picture 36 – Calibration test
Here is a value for
correct dose in kg/ha
Here the
calibration test
(in this case seed)
Carefull! for 100 kg
must fill as 0100.0!
Select the corresponding
feeder (using side
rotation knob)
Set what speed you
will move during test
Use this key to start
the calibration test
This is where the
required batch is
entered in kg/ha
(100kg/ha)
Setting
approximate
calibration factor
depends on the
seed type and its
dose
Fill up the feeder
turnstile
Dispenser 1 (Motor 1)