FANOX SIL-D00, User Manual, Page: 151 / 226

www.fanox.com Rev.06 151/226
Changing remote protocol through general settings is only available for SIL-DxxxxxA(D,I)xxxx. Remote protocol will depend on the model, this is:
SIL-DxxxxxA(D,I)xxxx:
It is possible to select remote protocol between MODBUS and IEC60870-5-103 though general settings.
SIL-DxxxxxB(C,E,F,G,H) remote protocol is impossed by the model and each model correspond to a concret protocol. These protocols can be: Modbus
RTU (RS485) and IEC61850, DNP3.0, Modbus TCP or IEC60870-5-104 (RJ45). In this case the protocol can not be changed from General settings.
It is necessary to enter a password to change a setting for the first time. The settings can be changed after entering the password, until returning either
manually or automatically to the standby mode screen. The system returns automatically to the standby mode screen if no key is pressed for five
minutes.
The factory setting password for the equipment is 5555. This password can be changed using the SICom program.
The keys ▲, ▼, ◄ and ► are used to enter the password. ▲ and ▼ are used to introduce a value or a character, and the ◄ and ► keys are used to
move from one character to another. If it is necessary to change one of the password characters or numbers due to an error, press "
C " to delete it.
Press " OK
” to validate the password.