Fagor CNC 8070, Hardware Configuration

Page: 212 / 276

Hardware configuration.
CNC 8070
10.
HORIZONTAL KEYB
/ HO
RIZONTAL KEYB+MOUSE.
Hardw
are fu
ncti
ona
lities.
·212·
(R
EF
: 1911)
Keys of a passive monitor.
Connection of the keys of the LCD15 passive monitor. Maximum cable length is 1 meter.
24 V DC voltage supply.
CAN bus.
CAN bus. Address (node) of the element within the bus (0-15).
The "Address" switch also sets the priority of the node within the bus; the lower the number
the higher the priority. We recommend the keyboard and jog panel to be the last nodes of
the bus.
Connector data.
Number of poles. 3.
Pitch. 7.62 mm.
Connection technique. Screw connection.
Minimum/maximum tightening torque. 0.5 / 0.6 Nm.
Minimum/maximum section.
0.2 / 2.5 mm².
Minimum/maximum AWG section. 24 / 12.
Rated current In. 12 A.
Cable data.
Length to be stripped. 7 mm.
See "10.5 Power supply for the module." on page 210.
Connector data.
Number of poles. 5.
Pitch. 3.5 mm.
Connection technique. Screw connection.
Minimum/maximum tightening torque. 0.22 / 0.25 Nm.
Minimum/maximum section.
0.14 / 1.5 mm².
Minimum/maximum AWG section. 28 / 16.
Rated current In. 8 A.
Cable data.
Length to be stripped. 7 mm.
See "10.7 Bus CAN (CANfagor/CANopen protocols)." on page 214.
Each one of the elements integrated into the CAN bus is identified
by the 16-position rotary switch (0-15) "Address" (also referred to
as "Node_Select"). The CNC must always occupy position "0" and
the rest of the elements of the bus will occupy consecutive
positions starting with "1".
Plug-in part. 3-pole Phoenix-type combicon connector (7.62 mm
pitch).
Pin Signal. Function.
1 Chassis.
2 GND 0 V reference signal.
3 +24 V Power supply.
1
Plug-in part. 5-pole Phoenix-contact minicombicon connector (3.5 mm
pitch).
Pin. Signal. Function.
1 GND Ground / 0 V.
2 CL (LOW) bus signal.
3 SH CAN shield.
4 CH (HIGH) bus signal.
5 SH CAN shield.