Fagor 8040 MC CNC, Manual

Page: 64 / 247

Chapter 2 - page 2
MC work mode 2. Operating in JOG mode
2.1 Introduction
2.1 INTRODUCTION
The standard MC operating mode screen contains the following information:
1.- Clock
2.- This window can display the following data:
SBK when the Single Block execution mode is selected.
DNC when the DNC mode is activated.
P..... number of the program selected.
Message «In Position» - «Execution» - «Interrupted» - «RESET»
PLC messages
3.- The CNC messages are shown in this window.
4.- This window can display the following data:
* The X, Y, Z coordinates of the axes.
* In small characters, the axis coordinates referred to machine zero reference (home). This
values are very useful when allowing the operator to set a tool change position (see zone 6).
The CNC does not show this data when text 33 has not defined in program 999997.
* The coordinates of the auxiliary axes which are defined.
* The real spindle rpm "S".
5.- The information shown in this window depends on the position of the left-hand switch.
In all cases, it shows the feedrate of the «F» axes that has been selected and the % of F being
applied.
When Feed-hold is active, the feedrate value changes colors.
All the possible cases are shown below.