DXP HD 4K PLUS Series • Operation
14
Config port
— This USB mini-B port serves a similar communications function to
the rear panel Remote port, but is easier to access than the rear port after the matrix
switcher has been installed and cabled. Use a USB type A to mini-B cable to connect
this port to a USB connector on the computer to enable SIS commands to be sent from
the computer, connection to the PCS configuration software, and uploading firmware.
NOTE:
A front panel Config port connection and a rear panel Remote port
connection can both be active at the same time. If commands are sent
simultaneously to both ports, the command that reaches the DXP first is handled
first.
Input buttons
— The input buttons have the following functions:
Primary:
•
Select an input.
•
Identify the selected input.
Secondary:
•
Save and recall presets (see
on page 22.
Output buttons
— The output buttons have the following functions:
Primary:
•
Select outputs.
•
Identify the selected outputs.
Secondary:
•
Save and recall presets (see
).
•
Mute video and audio output (see
Muting and Unmuting Outputs from the
Front Panel
on page 23).
•
De-embed HDMI audio signals from the input.
Control buttons
— The three Control buttons have the following functions:
•
Enter
button
— The
Enter
button has the following functions:
Primary:
•
Save changes made on the front panel.
•
Indicate that a potential tie has been created but not saved.
•
Indicate that a preset has been selected to be saved or recalled but the preset
action has not been completed.
Secondary:
•
Select 9600 baud rate for the Remote RS-232 port.
•
Set the front panel lock mode (executive mode).
•
In conjunction with the
Preset
and
Esc
buttons, place the switcher in serial
port configuration mode.
•
Indicate that the Remote RS-232 port is set to 9600 baud in serial port
configuration mode (blinking).
