S
UMMIT
S
WITCH
I
NSTALLATION
AND
U
SER
G
UIDE
4-9
S
UMMIT
C
OMMANDS
U
SER
A
CCOUNT
C
OMMANDS
Table 4-5
describes user account commands.
config devicemode [bridging | iprouting ]
Configures the operating mode of the Switch.
Specify:
■
bridging
— Layer 2 bridging functions only
■
iprouting
— Bridging and IP unicast
routing functions
If this command is used to change the
operating mode of the Summit once it is up
and running, it causes the Switch to save the
configuration and reboot. The default
operating mode is
iprouting
.
unconfig switch {all}
Resets all Switch parameters (with the
exception of defined VLANs and IP
addresses) to the factory defaults. If you
specify the keyword
all
, the IP addresses are
reset as well.
ping {continuous} {size <number>} <ipaddress> Sends ICMP echo messages to a remote IP
device. Specify:
■
continuous
— ICMP echo messages
should be sent continuously.
■
size <n>
— The size of the packet.
The
continuous
option can be interrupted by
pressing any key.
traceroute <ipaddress>
Traces the routed path between the Switch
and a destination endstation.
clear counters
Clears all statistical counters for the Switch
and ports.
Table 4-4: General Switch Commands (continued)
Command
Description
SUMMIT.BK Page 9 Thursday, September 25, 1997 12:33 PM
