Extreme Networks Alpine 3802, Hardware Installation Manual

Page: 279 / 394

Configuring I/O Modules
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide 279
F32Fi Module
Figure 160 shows the F32Fi module.
Figure 160: F32Fi module
All F32Fi ports have 32 100BASE-FX ports and use standard MT-RJ connectors.
The default configuration of the F32Fi modules is as follows. All ports:
• Are added to the default VLAN as untagged.
• Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).
• Operate in 100 Mbps, full-duplex mode. Half-duplex mode is not supported.
LEDs
The F32Fi module has the following LEDs:
• Module status
• Port status
For information about the LEDs and their activity on the F32Fi module, see “I/O Module LEDs” on
page 293.
Software Requirements
The F32Fi module requires ExtremeWare version 6.1.8 or later and BootROM 6.5 or later.
BD_F32Fi
Port status LEDs
Module status LEDs
100 Mbps
ports
3
4
2
1
11
12
10
9
19
20
18
17
27
28
26
25
7
8
6
5
15
16
14
13
23
24
22
21
31
32
30
29
4
1
20
17
8
5
24
21
12
9
28
25
16
13
32
29