Extreme Networks Alpine 3802, Hardware Installation Manual

Page: 292 / 394

292 Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
BlackDiamond 6800 Series I/O Modules
ATM Module LEDs
The ATM module is equipped with two module-level LED indicators (STATUS and DIAG) and one
port-level LED indicator for each network interface port on the ATM module (see Figure 169).
• STATUS LED—Located near the top end of the ATM module front panel, near the ejector/injector
lever. This LED indicator is a bi-color LED (lighting either green or amber) that signals the operating
status of the module as a whole.
• DIAG LED—Located beside the STATUS LED. This LED is a single-color LED (lighting amber only)
that flashes amber when diagnostics are running on the module, and is solid amber if the module
fails the diagnostics.
• Port-level LED—Located next to the port number identifying each fiber optic network interface
connector on the front panel of the module. The port LED is a bi-color LED (lighting in either green
or amber) that signals the operating status of that network interface port.
NOTE
During the ATM module boot up, the STATUS and DIAG LEDs may be incorrectly lit to solid green or
solid amber. The LEDs reflect their true state after approximately 30 seconds when the module has
completed its boot cycle.
For more information on ATM module LED activity, see “I/O Module LEDs” on page 293.
Service Ports
The ATM module is equipped with two front-panel service ports: one port is a DB-9 connector; the
other is a micro HD-15 connector (see Figure 169). Both ports are reserved for use only by Extreme
Networks technical support personnel for diagnostic purposes.
Software Requirements
The ATM module requires ExtremeWare 7.0 or later on both the MSM module and the ATM module,
BootROM 7.8 for the MSM module, and BootROM 1.18 for the ATM module.
For more information about the software requirements, ATM module features, and ATM module
configurations, see the
ExtremeWare Software User Guide and the ExtremeWare Command Reference Guide .
Hardware Requirements
The ATM module is compatible with “i” series MSMs only. For the most current list of I/O modules
supported for use with the ATM module, consult your release notes.
ATM modules installed in a BlackDiamond chassis require at least one BlackDiamond Ethernet I/O
module also installed in the chassis in order to operate correctly.