Extreme Networks Alpine 3802, Hardware Installation Manual

Page: 199 / 394

Configuring I/O Modules
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide 199
connection to the Mogul-100. For more information about Mogul-100 configuration, see the Mogul-100
Quick Guide .
Configuring the FM-8Vi. The VDSL connection from the FM-8Vi to the Mogul-100 is automatically
established by the hardware on the two devices. There are no commands to configure this VDSL
connection.
However, the VDSL ports on the FM-8Vi connect to the Mogul-100 in such a way that the Ethernet port
on the Mogul-100 behaves as though it is located on the Alpine switch. When you configure a port on
the FM-8Vi, you are configuring the Ethernet port on the Mogul-100. For example, when you add port 2
on the FM-8Vi to a VLAN, the Ethernet port on the Mogul-100 connected to port 2 of the FM-8Vi now
belongs to that VLAN.
The ports on the Mogul-100 that are controlled by the FM-8Vi accept configurations using the same
commands and procedures as the ports on the FM-32Ti and FM-24Fi modules, except that the ports can
only be configured for 10 Mbps.
The slot configuration command now includes a keyword to specify the FM-8Vi. To configure the slot
for the FM-8Vi, use the following command:
config slot <slot> module fm8v
The following example configures slot 2 for the FM-8Vi module:
config slot 2 module fm8v
Displaying VDSL Statistics. For the FM-8Vi module, the show port command has been enhanced to
show VDSL statistics. To display VDSL statistics, use the following command:
show port <portlist> vdsl stats
The following command displays the VDSL statistics for ports 2:1 through 2:4:
show port 2:1-2:4 vdsl stats