
295
TRIM AND TILT
SERVICING
13
Remove drive coupler from either the motor or the
pump assembly.
Assembly
IMPORTANT:
Use only
Evinrude/Johnson
Bio-
degradable TNT Fluid to fill the hydraulic system.
Install drive coupler in pump assembly.
Install a new motor O-ring.
Position the motor on the manifold and install four
new
screws and lock washers. Tighten the screws
35 to 50 in. lbs. (4 to 6 N·m).
Oil O-rings and install them on the manual release
valve. Oil and install the manual release valve.
Tighten the valve to a torque of 45 to 55 in. lbs. (5
to 6 N·m).
Install
new
retaining ring in groove.
004281
004280
004282
004285
1.
Retaining ring
004283
1
Summary of Contents for E-tec 75 HP
