Evinrude E-tec 75 HP, Service Manual

Page: 272 / 344

272
GEARCASE
BEARING AND SEAL REMOVAL
Wrap the housing with a shop cloth to catch ball
and spring. Rotate the shifter detent 90° in either
direction, then pull the detent out of the housing.
Remove the detent ball and spring.
Remove needle bearings from bearing housing for
cleaning and inspection (“O” Type).
Pinion Gear Bearing
Remove pinion bearing retaining screw.
“S” Type Gearcases
Assemble Pinion Bearing Remover/Installer,
P/N 391257, in the gearcase as follows:
Use a mallet to drive the bearing from the hous-
ing.
“O” Type Gearcases
Use a 7/8 in. wrench to hold the remover in place.
Use a 3/4 in. wrench to turn flange nut clockwise.
Draw the bearing up from the housing.
1. Shifter detent
2. Ball and spring
DSC02518
1. Pinion bearing retaining screw
2. Water screen pocket
3. Seal
DSC02370
DRC7416
DSC02313
2
1
2
3
1
1. 1/4-20 x 1/2 in. Hex Head Screw
2. 1 in. O.D. Flat Washer
3. Plate, P/N 391260
4. Rod, P/N 326582
5. Installer/Remover, P/N 326574
6. 1/4-20 x 1 1/4 in. Hex Head Screw
824163
1. Flange nut, P/N 326586
2. Plate, P/N 391260
3. Rod, P/N 326582
4. Remover, P/N 326579
DR3419
1
2
3
4
5
6
1
2
3
4